Construction Details - Clip-In

 

System overview




 

1= Nonius hanger                                
2= Rod hanger                                    
3= Wall bracket                                  
4= Primary-/ secondary clip-in profile     
5= Clip-in profile splice                      
6= End clamp
7= Cross connector

A= 1250mm
B= 1200mm
C= 250mm
D= Tile size  
E= 1250mm 

 

Characteristics

  • Square/ rectangular tiles clipped in non-visible supports for a smooth monolithic look


 

  • Tiles are standard available in steel (0.5mm), other materials are available on request


Clip-In 3 mm Bevel - "Tile Options"

 

Module in mm Gauge: steel  Alu.
600 x 600 0.5  0.6 
625 x 625 0.5 0.6
300 x 600 0.5 0.6
312.5 x 625 0.5  0.6
300 x 1200 0.5 0.6

 
  • 3 mm wide bevelled edges emphasising the crispness of the design with fine joint lines
  • Optimal acoustic control by using perforated tiles with a non-woven textile membrane bonded to the inside face
  • Easy demountable tiles, which allows full access to services and equipment in plenum
  • Self levelling tiles resulting in a smooth ceiling surface
  • Swingdown tiles for enhanced access into the plenum are standard available
  • Base Material: LuxalonŽ Clip-In tiles are available in electrolytic-galvanised steel, phosphatised and chemically treated in accordance with high industrial standards (DIN 1541/BS 1449, part 1:1983/TAIM standards). Zinc coating is double sided and 2.5 microns. Aluminium alloy AL 99.5RA, 3/4 hard (according to DIN 1783) or stainless steel alternatives are also possible, when required
  • Coating: the tough and durable polyester powdercoating finish in a minimal thickness of 60 microns, is electrostatically applied ensuring uniform coating thickness, absolute adhesion, maximum resistance to abrasion. Because LuxalonŽ coatings are applied after perforation and bending process, exposed edges are protected. Standard gloss rate is 15 - 20% at 60° angle of incidence
  • Tolerances: as a member of the Technical Association of Industrial Metal Ceiling Manufacturers (TAIM), Hunter Douglas complies with tolerance criteria as specified in chapter 4 of the TAIM Quality standards for metal. The TAIM standards are available on request

 

Fire behaviour

Suspended LuxalonŽ metal ceilings are classified incombustible, and will therefore not contribute to possible fires. When ceilings however need to protect the structural integrity of a building, LuxalonŽ ceilings offer a wide range of practical solutions with regards to fire resistance and fire stability. Further information is available on request.

Material per sqm

 

Components Units 600 x 600 625 x 625
Tiles  pcs  2,78  2,56
Clip-In Rail m1 2,50 2,43
Rail Connector pcs 1,39  1,34
Rail Splice pcs 0,50 0,49
Suspension pcs 0,67 0,67